Ambient TOUCH LIGHT Instructions d'exploitation télécharger pdf (Page 5)

50D0092 Rev 4 Feb 2005 Page 5 of 9 Ambient Technologies

ADivision Of

1. The Touch Light transmitter comes preset from the factory with a 2 hour shutdown timer from its last ON

operation. This is done to prevent the appliance from continuing to run if left unattended.

2. You may disable this feature if you wish. To disable, change the Touch Light transmitter privacy (DIP)

switch #1 ONLY to the OFF position (by sliding the switch towards the battery door.) Make sure the

receiver privacy (DIP) switches are set the same. Follow the instructions on how to set the privacy (DIP)

switch setting.

3. By disabling this feature, your appliance may continue to run unattended.

Reset Button:

1. The reset button can be used to reset the transmitter if transmitter is not working properly. The reset

button is located behind the battery door cover. Press the reset button and the transmitter will reset and

initialize for 10 seconds before it can be used.

Where to place Touch Light Transmitter?

1. The Touch Light transmitter is recommended to be placed on a

non metal table top or wall mount. Make sure there is no direct

contact of metal parts to the body of the transmitter.

2. If wall mount, choose a mouting location about 5 feet above the

floor in an area with good air circulation and away from the

following:

a. Air ducts

b. Radiant heat from the sun and appliances

c. Concealed pipes and chimneys

3. Align the wall bracket to the desired location. Mark two (2) holes

using the wall bracket as template.

4. Drill two (2) holes and insert the plastic anchors until they are flush

with the wall.

5. Fasten securely the wall bracket to the wall with the two (2) screws.

6. Refer to the figure on how to install the transmitter to the wall bracket.

OPERATIONS:

1 2 3 4 5 6 7 8 9

Pas de commentaire

Ambient TOUCH LIGHT Instructions d'exploitation Page 5