Ambient Wireless TC Slate - ACD 301 RF Manuel d'utilisateur

CLOCKIT MASTER SLATE ACD 301 / RF Time code Slate MK III - 2009 Ambient Recording GmbH Schleissheimer Str.181 C, D-80797 Muenchen Tel: +49 89

10 1.2.3 External TC frame rate identification Press BLUE button to display the Generator frame rate and next to it the external TC

11 Note: The generator still counts during set mode so no time is lost by entering and leaving set mode in the above manner. 1.3.4 The curs

12 DD MM YY XX When working with an Aaton or Aaton system cameras, or setting the Internal RTC this format must be used. 1.3.7 The AMPS config

13 When Load is implemented only the generator is loaded with the selected data.

14 1.3.11 Setting the generator There are three settings of the DIP-switches in which the generator is active. A Generator Mode B Generator/ RT

15 1.3.12 Setting the Real Time Clock (RTC) The RTC can only be set with the slate in generator RTC mode To enter values from running generator

16 Red LED goes ON, then the Green LED flashes.

17 2 Operating modes 2.1 Generator Mode OFF 4 5 ON The Clockit master slate contains a very accurate time code

18 2.2 Generator RTC Mode OFF 4 5 ON This mode has the same function as the generator-only mode with the

19 3 New features in ACD301RF MKIII 3.1 CLOCKIT Radio Slate The CLOCKIT Radio Slate is a combination of a small UHF teleme

2 Table of contents 1 User instructions 1.1 Controls & Control elements 1.1.1 The DIP- switches 1.1.2 Brightness control 1.1.3

20 3.2 Operating Note The slate can be used to show the camera the userbits before rolling over. This is done by pressing the RED

21 4 TECHNICAL DATA: 4.1 Mechanical Specification Dimensions 250 x 160 x 26 mm Weight 960 g (no batteries) 4

3 1 User Instructions 1.1 Controls & Control elements Bottom edge ON/OFF switch

4 Front 2 RED flash-LED’s RED and GREEN single LED LED display with Anti-glare mask and polarizing red filter Writing surface fo

5 1.1.1 The DIP-switches There are two switch field’s inside. One with 12 DIP-switches and one with 4 DIP-switches. Their functions

6 DIP-switch with 4 switches: 1 TRX OFF / ON Transceiver is transmitter when slate is in GEN mode, receiver when in READ or

7 When the generator is set from an external source while it is running the Red LED will go on shortly and then the Green LED will flash at 1 sec. i

8 turn is “tuned” to GPS (factory setting) or to a fixed offset to match another machine by the user. Full details of this process will

9 1.2 Check features The slate can be used to implement all time code checking functions required on the set using the internal Clockit gen